Simplex 4100 Operator's Manual

10-1
These procedures should be followed when the system is installed and during periodic testing
as required by code. Check local codes to determine how frequent you system should be
tested. Always inform appropriate personnel (Fire Brigade, etc.) that you will be testing the
system.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Walk Test™ 10-2
Walk Test™ FEATURES 10-5
Walk Test™ PROCEDURES 10-8
Chapter 10
System Test Procedures
Introduction
In this Chapter
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes