Simplex 4100 Operator's Manual

3-4
You can view the list of acknowledged fault or isolate conditions at any time by using the
following procedure.
1. Press the <FAULT ACK> or <ISOLATE ACK> key to enter the fault or isolate list. The
first fault or isolate condition in the list appears in the display. The top line indicates the
custom label of the point. The bottom line contains two parts. The left side of the bottom
line shows the type of device. The right side of the bottom line identifies the type of
condition, fault or isolate.
2. At this point, each time you press the <FAULT ACK> or <ISOLATE ACK> key, the
next point in the list appears. (You can also use the <NEXT> and <PREV> keys to do
this.
Viewing Fault or Isolate Conditions
Overview
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes