Simplex 4100 Operator's Manual

8-1
When an abnormal condition occurs, a record of the event is placed in one of two logs
generated by the system, depending on the nature of the condition. These logs are:
• Historical Alarm Log
• Historical Fault Log
The historical logs contain a time stamp of the events surrounding abnormal conditions in the
system. The information displayed with these lists are historical data only and will not contain
any current point status. Separate lists are maintained for alarms and for isolates/faults. This
chapter describes displaying and clearing these lists.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Viewing and Clearing the Historical Alarm and Fault Logs 8-2
Chapter 8
Viewing and Clearing Historical Logs
Introduction
In this Chapter
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes