Simplex 4100 - Displaying Software Revision; Overview

9-3
Follow these steps to display software revision information.
1. Press the MENU key.
2. Press the NEXT and PREV keys until the prompt reads, “Display Software Revision
Level?”
3. Press ENTER. A display similar to the following appears.
4. Interpret this information as follows.
• SYS REV. Specifies the revision of the executive software (operating system of the
FIP) loaded on the panel.
• CFIG FORMAT: Defines the compatibility of the executive and the programmer.
• JOB: Specifies the name of the job loaded on the panel.
• REV. Specifies the revision of the job.
Displaying Software Revision
Overview
SYS REV: A9.02.13 CFIG FORMAT:
96JOB: JOB1 REV:6 13-OCT-00
firealarmresources.com