Argus Radar - TROUBLESHOOTING
988-10187-004 5.1
CHAPTER 5
TROUBLESHOOTING
5.1 Introduction
This chapter provides the procedure that must be followed in order to replace a
failed component of the Argus system.
5.1.1 Safety Precautions
If not otherwise specified in the procedures, during the corrective maintenance
operations, the following safety rules must be observed:
Each maintenance operation must be carried out only after the equipment is
switching off.
WARNING
SET THE MAIN BREAKER OF THE EQUIPMENT TO OFF, AND HANG
UP A PLACARD READING "WORK IN PROGRESS DO NOT SWITCH
ON".
Before removing any component, be sure the spare part is available.
Verify the integrity of the spare part and, if possible, perform a functional test.
5.1.2 Personnel
Only skilled personnel with a good knowledge of the equipment may carry out
service and replace parts.
5.2 Required Tools and Instruments
To carry out the operations described in this chapter, only normal workshop
tools (as screwdrivers, wrenches etc.) are required.
The tools required to perform the operations are:
• set of cross and slotted screwdrivers;
• set of socket and torx wrenches;
• scissors;
• Tweezers.
To Next Page
Loading...
