Argus Radar - Installation and service manual
988-10187-004 7
SW2 switch (red rotary component)
SRT control PCB
Safety Summary
The following general safety precautions are not related to any specific
procedure and therefore do not appear elsewhere in this technical manual.
These are recommended precautions that personnel must understand and
apply during most phases of operation and maintenance.
KEEP AWAY FROM ANY LIVE CIRCUITS!
Operating personnel must at all times observe all safety regulations.
Do not replace components or make adjustments inside the unit with the high
voltage supply turned ON. Under certain conditions, dangerous potentials may
exist when the power breaker is in OFF position, due to charges retained by
capacitors. To avoid danger and casualties, always remove power and
discharge to ground a high voltage circuit before touching it.
DO NOT SERVICE OR ADJUST YOURSELF!
Under no circumstances should any person initiate servicing or adjusting the
unit except in the presence of authorized personnel.
RESUSCITATION
Personnel working with or near high voltage should be familiar with modern
methods of resuscitation. Such information may be obtained from the Bureau of
Medicine and Surgery or equivalent.
To Next Page
Loading...
