SMA sunny home manager - Tariff Configuration

Procedure:
1. Select Configuration > PV system properties in the page and menu selection.
2. Select the tab PV System Data.
3. Select [Edit].
☑ The menu for setting system data opens.
4. Select [No PV system image] in the area PV system image.
5. Select [Save].
12.8 Entering the Feed-in Tariff, Self-Consumption Tariff and
Electricity Tariff
The values entered for the feed-in tariff, self-consumption tariff and electricity tariff affect the
following components:
• Recommended actions in the diagram Forecast and Recommended Action on the page
Current Status and Forecast
• Load control via the SunnyHomeManager (either directly via cable-based communication or
indirectly via radio-controlled sockets)
Requirement:
☐ You must have the user role Installer or PV System Administrator (see Section13.1,
page120).
Procedure:
1. Select Configuration > PV system properties in the page and menu selection.
2. Select the tab Parameters.
3. Select [Edit].
☑ The menu for parameter settings opens.
4. Enter the feed-in tariff per kWh in the area Reimbursement in the text field Feed-In Tariff.
Also select the desired currency in the accompanying drop-down list.
5. In the text field PV system with self-consumption, select whether self-generated PV energy
is consumed in your household (self-consumption). If you select Yes (default setting), the self-
consumption of the household is taken into consideration in the load control and
recommended actions.
6. If you receive compensation for self-consumption, enter the self-consumption tariff in the text
field Self-Consumption Tariff.
7. If you do not receive compensation for self-consumption, enter 0 in the text field Self-
Consumption Tariff.
12 System Settings
SMA Solar Technology AG
User Manual 113HoMan_Portal-BA-en-20