SMA sunny home manager - Load Configuration Procedures

☐ You must be a Standard user, Installer or PV system administrator (see Section13.1,
page120).
Procedure:
1. Select Load Balance and Control in the page and menu selection.
2. Select the Current tab.
3. In the table, in the column Operating mode, select the button for the desired operating mode
next to the required load.
4. Select the desired operating mode:
Operating mode Explanation
Automatic Control of the Plugwise radio-controlled socket via the
SunnyHomeManager.
Depending on the current control command of the
SunnyHomeManager, the Plugwise radio-controlled
socket is either switched on or off in this mode.
This operating mode cannot be set for the load type
Measure only
Switch on No control of the Plugwise radio-controlled socket via
the SunnyHomeManager.
The Plugwiseradio-controlled socket is switched on and
switches to the operating mode On. The connected
load can draw electric current.
Switch off No control of the Plugwise radio-controlled socket via
the SunnyHomeManager.
The Plugwiseradio-controlled socket is switched off and
switches to the operating mode Off. The connected
load cannot draw electric current.
☑ After a short time, the selected operating mode is shown as activated on the SunnyPortal user
interface.
9.3 Configuring Loads
9.3.1 Calling Up the Properties of a Load
The tab "Name of Load" on page Load Overview and Planning displays the properties of the
load. Depending on the selected load type, you can display and configure different load properties
on the tab.
Requirement:
☐ You must be a Standard user, Installer or PV system administrator (see Section13.1,
page120).
9 Load Control
SMA Solar Technology AG
User Manual 79HoMan_Portal-BA-en-20