SMA sunny home manager - Configuring Plugwise Socket Modes

3. In the table, in the column Operating mode, select the button for the desired operating mode
next to the required load.
4. Select the desired operating mode:
Operating mode/LED behavior Explanation
Automatic/LED is flashing orange
(switched off) or green (switched
on)
Control of the SMAradio-controlled socket by the
SunnyHomeManager
Depending on the current control command of the
SunnyHomeManager, the SMAradio-controlled
socket is either switched on or off in this mode.
This operating mode cannot be set for the load type
Measure only
Switch on/LED is glowing green No control of the SMAradio-controlled socket by the
SunnyHomeManager
The SMAradio-controlled socket is switched on and
switches to the operating mode On. The connected
load can draw electric current.
Switch off/LED is glowing orange No control of the SMAradio-controlled socket by the
SunnyHomeManager
The SMAradio-controlled socket is switched off and
switches to the operating mode Off. The connected
load cannot draw electric current.
☑ After a short time, the selected operating mode is shown as activated on the SunnyPortal user
interface.
9.2.6.2 Setting the Operating Mode of the PlugwiseRadio-Controlled
Socket
Configuring Plugwise radio-controlled sockets
You can only set the operating mode of Plugwise radio-controlled sockets that are managed
via the SunnyHomeManager via Sunny Portal or the Sunny Portal app.
Plugwise radio-controlled sockets that are managed via the SunnyHomeManager can not be
configured via the Plugwise app. Only the data of these Plugwise radio-controlled sockets will
be displayed. If you would like to manage a specific Plugwise radio-controlled socket via the
Plugwise app, you must remove this from your SunnyHomeManager system (see
Section10.5, page98).
Requirements:
☐ The Plugwise radio-controlled socket must be assigned to the connected load (see
Section9.2.4, page76).
☐ In SunnyPortal, the data request interval must be set to Automatic (see Section8.7,
page69).
9 Load Control
SMA Solar Technology AG
User ManualHoMan_Portal-BA-en-2078