-48-
No.EX※※-OMS0027
•Digital I/O unit parameters (2)
No. Parameter Definition Item Content
Default
setting
Parameter
setting range
Enable
Generates an error.
Val: 1 to 65000
5
10
Input or
Output
ON/OFF
counter
Generates error
when the operation
count exceeds the
set value.
4
Disable
Does not generate an
error.
○
Channel
11
Input or
Output
ON/OFF
counter clear
Clears the Input or
Output ON/OFF
counter to 0. (Refer
to page 83 for the
clear meth
od).
- - -
-
1: Could be incorrectly recognized as short circuit depending on used load (ex.: lamp load). If detection is incorrect, disable the
parameter setting.
2: This function is valid only when "Hold/Clear priority" of the system parameter is set to "Via software".
3: Some PLC does not support an idle mode.
4: The count is memorized every hour. When the power supply is turned on again, counting starts from the last value memorized.
5: Times for setting is set value x1000 times.
To Next Page
Loading...