58
D335 User Manual Using the Phone
• In Fig. 4–6 there are two calls on hold. Fig. 5 and 6 both show the second held call, in short label
display mode (Fig. 5) and in full label display mode (Fig. 6). Press the function keys underneath
/ or / to show the call not currently on-screen.
Fig. 4 Fig. 5 Fig. 6
• When the connected call is on-screen, you can transfer it to a third party or terminate it by
pressing .
• When a held call is on-screen, press to connect to it and put the currently connected call on
hold.
Conference
The maximum number of participants is three.
Note: This section refers to phone-based conferences. For the number of participants
in server-based conferences and how to set them up and participate, please check with
your network administrator or your VoIP provider.
Initiating a conference
1.
2. Call the second intended participant.
Fig. 1
3. When you are connected to the participant, press to start the conference.
Conference screen navigation
contact area of the display. Example: A conference with three participants, including yourself. After
you have pressed (Fig. 1) to start the conference, the names, if available, and/or phone numbers
of the other participants are shown on-screen (Fig. 2–4). Fig. 2 shows the conference screen, i.e., all
of your conference partners while Fig. 3 and 4 show the screens for the individual participants.
To Next Page
Loading...
