MOTION CONTROL PANEL
TRANSPORT CONTROLS
Dedicated transport controls are provided for direct control over Pro Tools:
ON LINE* Puts the DAW on line for synchronisation.
LOOP* Toggles Loop mode on/off (hold down CTRL for Loop Record mode).
Q PUNCH* Toggles Quickpunch recording status on/off for your DAW.
PRE* Toggles the pre-roll function for your DAW. See next page for setting Pre roll time.
POST* Toggles the post -roll function for your DAW. See next page for setting Post roll time.
*The status of these functions is shown in the transport section of the TFT screen.
IN Captures the current DAW position as the Start edit time.
OUT Captures the current DAW position as the End edit time.
RTZ (Return-To-Zero) Returns the playback cursor to the Session start time.
END Moves the playback cursor to the end of the Session.
REWIND Holding down this button will rewind the DAW (increment depends upon Display mode).
FAST FORWARD Holding down this button will fast forward the DAW.
STOP Stops playback or recording.
PLAY Depending on the HUI DAW settings commences playback from the current cursor position
or the last locate point, depending on DAW settings.
RECORD Engages DAW recording for currently armed tracks.
OTHER USEFUL TRANSPORT MODES
Half-speed Playback SHIFT + PLAY
Abort Current Record Pass SHIFT + STOP
Cycle through Record Modes (Normal, Quickpunch, TrackPunch, Loop) CTRL + RECORD
Cycle through Machine Control Masters (accessible via the transport window) CTRL + ONLINE
Link or Unlink the Edit and Timelines SHIFT + Back slash (/)
20
27
25 26
28
21
2422
23
20 22
DAW Control
AWS δelta Owner’s Manual Page 4-15
To Next Page
Loading...
Need help?
General
