AU
TOMATION
Motors Off Mode: Touch sense can be enabled or disabled.
Show MTC Display: Turn the timecode display on or off.
TALKBACK
Talkback switches are: Select the operation of the talkback buttons: Momentary / Latching / Auto
(Play) / Auto (Record).
L
isten switch is: Select the operation of the Listen buttons: Latching / Auto (Play) / Auto
(Record).
Red light switch is: Select the operation of the Red Light: Manual / Auto (Play) / Auto (Record).
TB switches disable Listen: This allows the Listen function to be switched off when talkback is activated,
thus avoiding feedback problems.
TB to FB: (Sums / Replaces) When assigning talkback to foldbacks, this option defines
whether talkback sums with or replaces the normal foldback signal.
See Communications for more details of these options
MONITOR SECTION
Monitor Gain Display: The calibration of the main monitor Gain pot and display can be set to one
of three industry-standard monitoring modes: Music (Off to 11) / Film (Off
to 95dB) / Gain (Off to 0dB)
Monitor Set CAL level: When in Film mode, adjust the calibrated listening level: 70 - 90 (dB).
See Monitor Level Display and Calibrated listening level for more details of these options
Solo Gain boost: Automatically increases the monitor level when a SOLO or AFL is activated
(Range: 0-10dB).
Isolated channels AFL on solo: Set solo-isolated channels to automatically solo in AFL (ON/OFF).
DESK SETUP
Input Cut Enable: If set ON, the channel strip CUT button will cut prefade sends, ie. Aux and
CHOP sends (ON / OFF).
Analogue Meter Scaling: Set the analogue level corresponding to 0dBfs on the console meters. (Range
18, 20, 22, 24 dBu).DAW SETUP
DAW setup parameters can be found in section 4 of this manual; see page 4-3 for more details.
DESK SETTINGS
Scribble Strip Brightness: Use this to adjust the channel scribble strip brightness (range: 1-6)
Turn Off Display After: Shuts off the TFT display after a predetermined time: 30 mins to 5 hours in
30 minute increments.
The scribble-strip displays can be turned off by turning the control pot clockwise (beyond 8 or 6) to ‘Off’.
On occasion, when changing the status of some of the above functions, you will be prompted to reboot your AWS
δelta
console. It is possible to do this without reaching the Power switch at the rear of the console through the addition of a
soft menu RESTART. When you select this you will be prompted to CONFIRM and your console will reboot.
Analogue Operations
AWS δelta Owner’s Manual Page 3-31
To Next Page
Loading...
Need help?
General
