SE
TTING
PR
E AND
PO
ST
RO
LL
H
old down
A
LT
a
nd press the
P
RE
o
r
P
OST
b
utton to highlight the left hand numeric field of the pre-roll or post-roll
time window. The time is displayed on the console TFT screen in place of the DAW position. The selected numeric field
will flash. Use the navigation left/right arrow keys to select a different numeric field if required, then enter a value on the
numeric keypad or use the Up/Down arrow keys to increase or decrease the selected field.
Press
ENTER to confirm the time.
The CLR button on the numeric keypad can be used to clear the selected time.
SE
TTING START
(IN) A
ND END
(OU
T
) TI
MES
Hold down ALT and press the IN or OUT button to highlight the left hand numeric field of the start or end time window.
The time is displayed on the AWS TFT screen in place of the DAW position. The selected numeric field will flash. Use
the navigation left/right arrow keys to select a different numeric field if required, then enter a value on the numeric keypad
or use the Up/Down arrow keys to increase or decrease the selected field.
Press ENTER to confirm the time.
The CLR button on the numeric keypad can be used to clear the selected time.
AUDITION
This function allows the IN, OUT, PRE and POST points to be checked.
Select the AUD button then press either the PRE, IN, OUT, or POST button. Press the AUD button again to cancel
the function.
When Audition mode is selected the transport section of the TFT screen displays audition in place of the Pre and Post
indicators.
PRE Plays from the pre-roll point to the selection start point
IN Plays from the selection start point for the post-roll time
OUT Plays from the end point less the pre-roll time to the end point
POST Plays from the selection end point for the post-roll time
ALT+OPTION+PRE (or IN) Plays from the selection start point minus the pre-roll time to the selection
start time plus the post-roll time
ALT+OPTION+POST (or OUT) Plays from the selection end point minus the pre-roll time to the selection
end point plus post-roll time.
AWS FOOTSWITCH CONTROL
The AWS has two 6.35mm jack footswitch connectors on the rear of the console (see Section 3). These are intended for
hands-free access to essential transport functions:
Footswitch Control One: Either plays or stops the DAW. Holding down SHIFT will abort a recording
if in record, or initiate half-speed playback if stopped.
Footswitch Control Two: Used to activate or deactivate Record mode. Holding CTRL while pressing
the foot switch will cycle through record modes.
2
0
20
20
DAW Control
Page 4-16 AWS δelta Owner’s Manual