AWS δelta Operator’s Manual Page 7-27
Automation
TLock
TLock (Trim Lock) defeats the auto nulling feature of the standard Trim function and ‘locks’ the null point to the position
that the fader was in when Trim was first enabled in the current Mix Pass. This enables a defined trim offset to be
r
epeatedly punched in and out throughout the subsequent Mix Pass. Deselecting TLock clears any stored nulled points.
AutoTakeover can be used when TLock is active, however Snap and TLock are mutually exclusive; selecting one deselects
the other and vice versa.
An example of TLock would be bringing up
the levels of guitar licks in a track.
If Trim is used in Snap mode, the fader can
be raised and let go repeatedly, returning to
the previous level. However it is difficult to
have an identical increase in level each time
when using manually. If we use TLock, the
reference value will be set, and the fader will
be moved to the correct raised level. Every
time you press the fader status key it will
jump to that level, and when pressed again,
it will return to the reference value. There
will be no glide times and the value will be
identical.
Note: This feature is only available
with Motors OFF
Motors Off
Moff (Motors Off ) this mode suspends the motorised playback of Mix data via the moving faders. In this mode it will
emulate a VCA automation system. Moff automatically activates the fader SuspdAll Links function (see Page 7-19).
To Next Page
Loading...
Need help?
General
