Page 7-20 AWS δelta Operator’s Manual
Automation
To start a mix, press Execute. The screen switches to show level bargraphs for the 24 (16 for AWS 916) channel faders
and the two main faders, (for the MIX and REC busses).
The system saves a Global Static reference mix of the fader levels and cut status at their positions when the Execute
key is pressed. This is useful because it allows you to locate before the start of the mix and recover your original levels
(i.e.reference mix). Also, if you are writing automation in a section that had no previous mix data, when you drop out of
write the faders go back to their original levels.
Mix Running
Press Play on the DAW to move forward and as soon as the Mix system has locked to the MIDI timecode (MTC), the
Mix Status display will indicate ‘Mix Running’. Simply move the faders and press the cut switches to write your mix
automation, and the fader moves and cut data will be recorded. The DAW may be toggled freely between Stop and Play
and if Fast Forward is used or the DAW is located forward, the automation data will be extended to the new position and
returned to play.
AWS 948
You can write automation to the fader for either channel path by pressing the V-pot and switching the main fader’s path
assignment. Automation can not be written on the V-pot - the path must be flipped to the fader. The bargraph colour
will change from light grey to green when the secondary path is flipped to the fader, as shown for faders 18 and 19 above:
Automation can be written on both cut switches.
Channel Faders
Press End to save
the current Mix
Pass and return to
the List Mix menu.
Stereo Bus
Master Faders
Press Discard
to abort the
current Mix Pass
To Next Page
Loading...
Need help?
General
