Solidscape 3Z Series - Removing a File; Starting the Print Job

New Job Startup
16
Printer driver, select the PRINT button. Refer to the 3ZWorks User’s Manual, P/N 840202,
which is available on the Solidscape 3Z Series Software Flash Drive, P/N 945087.
3.3.3 Removing a file.
1. From the System Idle screen select More.
2. Select Clear Job.
3.4 Starting the Print Job
1. In the System Idle menu, insure all icons have a green check next to them.
2. Select Start.
3. The printer will complete a self calibration and then begin printing the model.
4. The Ready/Status indicator will display an animated file icon.