97
Additional Information
Nothing was recorded even though you set the
Synchro-Rec setting correctly.
, You forgot to turn off the connected equipment.
Turn off the connected equipment and set the
recorder to Synchro-Rec standby mode
(page 52).
, The recorder was not set to the Synchro-
Recording standby mode. Press SYNCHRO
REC (synchro recording) to have the recorder
stand by for recording. Make sure the
SYNCHRO REC (synchro recording) indicator
lights up on the front panel (page 52).
, The recorder is connected to the TV output jack
of the connected equipment.
Synchro-Recording does not complete.
, The timer setting for the connected equipment
overlapped the recorder’s timer setting
(page 53).
, There was a power failure during the recording.
The recorder automatically starts recording
when the satellite receiver is turned on.
, The Synchro-Rec function was activated. Turn
off the satellite receiver and cancel the Synchro-
Rec function (page 52).
The clock has stopped.
, Set the clock again (page 83).
, The clock stopped due to a power failure that
lasted for more than 1 hour. Reset the clock
(page 83).
The TIMER REC (timer recording) indicator is
flashing.
, The disc does not have enough space.
, Insert a recordable disc inside the recorder.
The recording mode indication is incorrect.
, When the recording or dubbing is less than three
minutes, the recording mode indication may be
displayed incorrectly. The actual recording itself
is correctly made in the selected recording mode.
, After playing titles recorded in SLP (super long
play) and SEP (super extended play) mode, the
recording mode indication may change
depending on the recorded program.
The clock does not appear in the front panel
display.
, “Dimmer” in “Options” setup is set to “Power
Save” (page 90).
, The “Power Save” in “Options” setup was set to
“On,” and the recorder is in standby (page 91).
Recording from the equipment
with a timer
Display
,continued
To Next Page
Loading...
