Sony STR-DA2800ES - Page 39

STR-DA2800ES
39
SPECIAL MENU MODE
Various version displays of system, update, test, etc. can be performed.
Setting method:
1. Press the [
?/1
] button to turn on the main power.
2. While pressing the [TONE MODE] button, press the [A.F.D.], [2CH/A. DIRECT], [MUSIC], [MOVIE/HD-D.C.S.] button in order, the
message “SPECIALIZED” appears.
3. Press the [AMP MENU] button of the remote commander, the message “< SPECIAL >” appears.
4. Press the [,] button of the remote commander, the item is appears.
5. Each time the [M] or [m] buttons of the remote commander is pressed, the item is switched in order of “Display of special menu mode”.
Some items can change the content. Display the cursor by pressing the [,] button of the remote commander, and changing the content
by pressing the [M] or [m] buttons of the remote commander, and fi x the content by pressing the [<] button of the remote commander
when you want to change the content of the item.
Releasing method:
To release from this mode, while pressing the [TONE MODE] button, press the [A.F.D.], [2CH/A. DIRECT], [MUSIC], [MOVIE/HD-
D.C.S.] button in order again, the message “MENU SPECIALIZE OFF” appears, and this mode is released.
Display of special menu mode:
Items Display Remark
SYSTEM version display SYS. vX.XXX X.XXX: System software version
MAIN Ucom version display M. A28 vX. XX X.XX: Main system controller software version
SUB Ucom version display SUB CCvX.XX X.XX: Sub system controller software version
FAROUDJA version display VIDEO vX. XX X.XX: Video system controller software version (main)
DSP serial fl ash version display SFLASHvX. XX X.XX: DSP serial fl ash software version
Network processor version display NET vRXXXX XXXX: Network processor fi rmware version
IR learning Ucom version display IR vXXXXXX XXXX: IR controller software version
DSP debug menu <DSP.DEBUG> Not used for the servicing.
Network debug menu <NET.DEBUG>
Menu mode to enter MAC address display. If the [,] button
of the remote commander is pressed, entering the menu, and
operating the following menu become possible.
MAC address display
(Network debug menu)
MAC XX:XX >
XX:XX: MAC address
When [,] button on the remote commander is pressed, the
continuation of the MAC address is displayed.
External control on/off
(Network debug menu)
EXT CTRL Not used for the servicing.
Network standby on/off
(Network debug menu)
NET STBY Not used for the servicing.
Network audio signal path switch
(Network debug menu)
AUD ROUTE? Not used for the servicing.
DAC error signal invalidity
(Network debug menu)
IGN DA-ERR Not used for the servicing.
Network compulsive party mode
(Network debug menu)
FORCEPARTY Not used for the servicing.
MT8555 USB update USB UPDATE
If the [
] button of the remote commander is pressed, update
of the network processor is started.
C4 identify C4 ID Not used for the servicing.
Home automation on/off HAT Not used for the servicing.
RS232C select 232C SEL Not used for the servicing.