Sony UP-D898MD - Page 32

1-24 (E)
UP-D898MD/X898MD
4. Thermal Head Voltage Setting
Sets the thermal head voltage setting value (D/A value).
To set the voltage setting value, change the value by operating the menu lever up and down when the
“H.V: (value)” is displayed, and then press the menu lever.
5. Low Pass Filter
Sets ON/OFF of the low pass filter circuit in IC302 on the MA-195 board.
The factory setting is “LPF:OFF”.
. LPF:ON: When setting the low pass filter to ON
. LPF:OFF: When setting the low pass filter to OFF
6. Log Print
Prints the log information (print count, error, etc.) in this unit.
Set paper in the tray.
7. Initialization of Setting
Initializes the setting and log information.
. INT:MENU: Initializes the content to be set by menu.
. INT:PWR: Resets the total power on time of switching regulator.
. INT:H:PRN: Clears the total print count of thermal head to 0.
Category Menu Normal Service tool (Printer
Settings)
GET SET
SAVE LOAD RE-
SET
INT
MENU
PWR H.PRN
Normal BRIGHT
OOOO OO
CONTRAST
OOOO OO
GAMMA
OOOO OO
SHARPNESS
OOOO OO
TONE
OOOO OO
ASPECT
OOOO OO
COLOR
OOOO OO
FIELD
OOOO OO
INTERRUPT
OOOO OO
MULTI
OOOO OO
SCALE
OOOO OO
SCAN
OOOO OO
SIDE
OOOO OO
S.H(NTSC)
OOOO OO
S.V(NTSC)
OOOO OO
E.H(NTSC)
OOOO OO
E.V(NTSC)
OOOO OO
S.H(PAL)
OOOO OO
S.V(PAL)
OOOO OO
E.H(PAL)
OOOO OO
E.V(PAL)
OOOO OO
DRIVER
OOOO OO
RESIZE
OOOO OO
BACKWORD
OOOO OO
INFO
OOOO OO
INVERT
OOOO OO
MIRROR
OOOO OO
QTY
OOOO OO