Source fire Sourcefire 3D System - Page 72

Version 5.2 Sourcefire 3D System Installation Guide 72
Installing a Sourcefire 3D System Appliance
Identifying the Sensing Interfaces
Chapter 3
Quad-Port 1000BASE-T Copper Non-Bypass NetMod
You can use these connections to passively monitor up to four separate network
segments. You also can use paired interfaces in inline configuration on up to two
network segments.
Quad-Port 1000BASE-SX Fiber Non-Bypass NetMod
The quad-port 1000BASE-SX fiber non-bypass configuration uses LC-type (Local
Connector) optical transceivers.
You can use these connections to passively monitor up to four separate network
segments. You also can use paired interfaces in inline configuration on up to two
network segments.
TIP! For best performance, use the interface sets consecutively. If you skip
interfaces, you may experience degraded performance.
Quad-Port 10GBASE (MMSR or SMLR) Fiber Non-Bypass NetMod
Link LED
Activity LED
Link LED
Activity LED
Ports
Activity LED Ports
Link LED