Soyer PH-9 SRM12 - Intended Use of the Stud Welding Device; Incorrect Use; Intended Use of the Stud Welding Guns

Important safety instructions
Operating Instructions Soyer Bolzenschweißtechnik 17
2.6 Intended use of the stud welding device
With the SOYER® BMK-8i ACCU stud welding device, pins and threaded studs
from M3 to M8 (preferably M6 and M8) made of steel or stainless steel can be
welded.
Special studs or diameters upon request.
The stud welding device can only be operated with the welding guns described
in chapter “7.4 Technical data of the BMK-8i ACCU stud welding device” on
page 31.
The stud welding device must be operated within the scope of technical data.
Only welding studs from Soyer (HZ-1 and MF types) may be welded.
The stud welding device supports the following welding procedures:
• SRM® welding (stud welding in a radially symmetric magnetic field)
• Drawn arc stud welding using shielding gas
2.6.1 Incorrect use
Any use of the device deviating from the intended use is considered as not intended.
Not intended use, unauthorised modification or manipulation of the device will
void the declaration of conformity and warranty claims against the manufacturer.
2.7 Intended use of the stud welding guns
With the SOYER® stud welding guns described in these operating instructions,
pins and threaded studs from M3 to M12 as well as many different weld fasteners
made of steel, stainless steel, aluminium and brass can be welded in accordance
with DIN EN ISO 13918.
Special studs or diameters upon request.
The welding guns can only be operated with the stud welding devices described
in the technical data of the gun.
The stud welding gun can only be operated within the scope of technical data.
i
The maximum diameter and type of the weldable studs may be
restricted by the capacity of the stud welding device at which the gun
is operated.