General information
6 Operating Instructions Soyer Bolzenschweißtechnik
1. General information
These operating instructions contain important information and rules for the
operation of the devices. Keep these operating instructions in a readily accessible
location close to the devices.
In these operating instructions, the term “devices” refers to the stud welding
device and the stud welding gun.
Carefully read the operating instructions and any other documents contained in
the technical documentation. Pay particular attention to the safety instructions
which are intended to help you recognise any possible residual risks and prevent
hazards.
The drawings and illustrations in these operating instructions are for illustrative
purposes and may vary slightly from the actual equipment.
The manufacturer reserves the right to make technical changes.
1.1 Validity of the operating instructions
These operating instructions apply to the following devices:
1.2 Registered trademarks
The following terms in these instructions are used with registered trademarks:
Stud welding device BMK-8i ACCU
Stud welding guns
PH-9 SRM
12
PH-9 SRM
12
+G
PH-3N SRM
SRM®: SRM corresponds to magnetic field stud welding and stands for
stud welding in a radially symmetric magnetic field [in German:
Schweißen im radialsymmetrischen Magnetfeld].
SOYER®: Developments/technologies of Soyer GmbH.
To Next Page
Loading...
