Soyer PH-9 SRM12 - Replacing the SRM Support Tube Insert of PH-9 SRM; Support Tube Insert of PH-9 SRM 12 +G

Description of the PH-9 SRM
12
+G stud welding gun
50 Operating Instructions Soyer Bolzenschweißtechnik
10.4 Replacing the SRM
12
support tube insert of PH-9 SRM
12
+G
In case of heavy wear or heavy contamination, it may be necessary to replace the
support tube insert.
Item number of the support tube insert: F06748
Use original spare parts only.
Replacing the SRM
12
support tube insert.
Step 1:
WARNING
WARNING
!
Switch off the stud welding device when the gun is
connected to it.
Step 2: Loosen the Allen screw of the earth
connection.
Step 3: Loosen the two threaded pins on the
support housing.
Step 4: Remove the old support tube insert.