Soyer PH-9 SRM12 - Technical Data of the PH-9 SRM; 12 +G Stud Welding Gun

Description of the PH-9 SRM
12
+G stud welding gun
Operating Instructions Soyer Bolzenschweißtechnik 45
With this stud welding gun, the earth connection is integrated into the gun in front
of the support tube insert. A separate earth connection on the workpiece is not
required.
The gun is equipped with a lifting magnet. The stud is lifted by the lifting magnet
before the welding process and lowered automatically for welding.
The height of the lift is also decisive for the welding result.
The lift height can be determined via the lift time using the stud welding device.
See chapter “13.1.5 Adjusting the lift time (height of lift) in the setting mode” on
page 69.
The height of lift is adjusted using the dial on the gun
(see Figure 6: "PH-9 SRM
12
+G stud welding gun").
The PH-9 SRM
12
+G stud welding gun has a gas insert for each stud chuck
diameter:
• M6: F06738
• M8: F06739
• M10: F06740
• M12: F06741
The gas insert is used to optimise the gas flow and to insulate the stud chuck
against the shielding gas shroud.
.
10.1 Technical data of the PH-9 SRM
12
+G stud welding gun
i
The PH-9 SRM
12
+G stud welding gun may only be operated with the
stud welding devices specified in the technical data.
Technical data of the PH-9 SRM
12
+G stud welding gun
Designation
PH-9 SRM
12
+G stud welding gun with integrated
earth connection
Item no. P02277
Welding procedure • Drawn arc stud welding
• SRM® welding procedure
Stud diameter M3 - M12 (depending on the stud welding device)
Stud chuck SRM® stud chuck
Stud length Standard up to 60 mm, special lengths on request
and possible with optional accessory