www.spacelabshealthcare.com
1-16
91390
QUBE
I NTRODUCTION
** Time can be shorter or longer depending on the battery performance.
Architecture
The basic internal architecture, or Printed Circuit Board Assembly
(PCBA), of the qube monitor, is shown in the System Block Diagram
(Drawing 1, Sheet 1). Refer to the drawings section of this manual for
more information.
The hardware for the monitor has the following features built around
the Microprocessor Controller (MPC) MPC8270:
•10/100BaseT Ethernet
• 266-MHz maximum CPU speed
• 66-MHz system bus for memories
• 32 MB Flash, 64 MB of SDRAM, and 2 MB SRAM
• 3.3-V logic design
• PCI2.2 at 33 MHz
A dark gray outline around a solid black battery icon shows that a battery slot is empty. After you install a
battery into the slot, the battery icon shows a white outline and the current charge level of the battery..
Power level
(one battery)
Power level
(two batteries)
Recorder
attached
Warning description
Audible
tones
**Approximate
time before device
shuts down
11% 6% Yes The message shown
lets you know that the
recordings stop.
soft 30 minutes
6% 3% Yes Yellow flashing battery
icon is shown. Message
shown lets you know
the recordings are
stopped.
soft 15 minutes
4% 2% With or
without
recorder
Red flashing battery
icon is shown. Message
shows that the battery
power level is critically
low.
loud 10 minutes
Table 1-5 Battery power level messages and tones
To Next Page
Loading...
