www.spacelabshealthcare.com
4-26
91390
QUBE
M AINTENANCE
Handle
1 Separate the bezel from the rear enclosure. Refer to Remove the
Bezel Assembly on page 4-8.
2 Remove the four screws on the handle cover as shown here
Figure 4-21 on page 4-26.
Figure 4-21 Handle
3 Remove the handle and dampening rod from the rear enclosure.
Reinstall the Rear Handle Assembly
1 Assemble the rear handle so that the dampening rod is inside the
tabs on the rear handle cover as shown in Figure 4-22 on page 4-
26.
Figure 4-22 Handle Assembly
2 To hold the dampening rod in place, slightly tilt the monitor
backwards. While it is tilted backwards, install the rear handle
assembly. Align the screws and holes. Secure the handle
assembly to the rear enclosure with the four screws.
To Next Page
Loading...
