Spacelabs qube 91390 - Diagnostics Failure Messages and Error Codes

www.spacelabshealthcare.com
5-14
91390
QUBE
TROUBLESHOOTING
Diagnostics Failure Messages and Error Codes
If the monitor fails power-ON diagnostics or extended diagnostics,
do the items that follow:
1 To verify the failure, power the monitor OFF and ON again or run
the extended diagnostics, as described in Diagnostic Menus on
page 5-8.
2 Once you verify the failure, take troubleshooting action or replace
the field-replaceable units (FRU) based on the diagnostics failure
messages that follow.
Table 5-1 Diagnostic Failure Messages
Error Code Diagnostics Failure Message Suggested Action
01030000 Diagnostics passed No action required.
01030001 Diagnostic(s) failed; degraded performance Replace CPU PCBA.
01030002 Critical failure Replace CPU PCBA.
01030003 Cannot diagnose at this boot stage No information available.
01030100 Diagnostics Port Test failed Replace CPU PCBA.
01030200 8260 Test failed Replace CPU PCBA.
01030201 8260 SCC Transmit failed Replace CPU PCBA.
01030202 8260 SCC configuration not recognized Replace CPU PCBA.
01030300 DRAM Test failed Replace CPU PCBA.
01030301 DRAM Test can’t allocate memory Reboot and retest. If problem
persists, replace CPU PCBA.
01030400 GDS RAM Test failed Replace CPU PCBA.
01030500 FLASH ROM Test failed Replace CPU PCBA.
01030501 FLASH ROM boot larger than Flash Reburn boot kernel software into
Flash memory and retest. If failure
persists, replace CPU PCBA.
01030502 FLASH ROM app larger than Flash Reburn application software into
Flash memory and retest. If failure
persists, replace CPU PCBA.
01030503 FLASH ROM boot checksum error Reburn boot kernel software into
Flash memory and retest. If failure
persists, replace CPU PCBA.
01030504 FLASH ROM app checksum error Reburn application software into
Flash memory and retest. If failure
persists, replace CPU PCBA.
01030505 FLASH ROM read/write memory test error Replace CPU PCBA.