www.spacelabshealthcare.com
2-9
91390 QUBE
S ETUP
Power LED
The monitor has a recessed momentary push-button switch on the
right side to toggle the unit between ON and OFF. To turn OFF the
monitor, hold the On/Off switch for three seconds. When you power
off the monitor, it also turns the power off to all devices drawing
power from the monitor, such as keyboards, mice, barcode readers,
Flexports, Pod interfaces, and printers.
If you switch the power off, it does not stop the charging of
batteries when connected to mains. Refer to Battery charger and
AC/DC power indicators on page 1-11 for details.
Battery Status LED
Refer to To change batteries without interruptions while operating
on battery power on page 1-15 for details.
Alarms
For information on alarms configuration and alarm tones, refer to
the XPREZZON™ and qube™ System Administration Manual.
Cables
Maximum Cable Lengths
The list of cables that follow are limited to the indicated maximum
length:
• SDLC Cable — 40 feet (12.2 m) maximum (total length from the
monitor to the last device on the bus). For longer SDLC cable
runs, contact your local customer service representative.
• DVI-D Video Cable — 16 feet without a repeater. For distances
greater than 16 feet, a repeater may be required in order to
guarantee signal quality.
• Ethernet cable (10/100BaseT) — 328 feet (100 m) maximum.
SDLC External Devices
External devices (for example, Flexport® system interfaces) can be
connected to the SDLC bus. In this context, the term external means
connected to the SDLC bus by cable through an external connector.
This is in contrast to modules, which are connected by inserting
them into a module housing.
To Next Page
Loading...
