www.spacelabshealthcare.com
4-23
91390 QUBE
M AINTENANCE
Connector Board PCB
1 Perform Step 1 on page 4-18 through Step 9 on page 4-19 to
access the Main Chassis assembly.
2 Remove the three screws, shown in Figure 4-18 for option A.
Remove the two screws for options B or C.
Figure 4-18 Connector Board PCB
Note:
Loosen the top three Monitor Dock PCB screws.
3 Remove the Connector Board.
4 Install the new Connector Board making sure that the connection
to the interface PCB is good.
Note:
Tighten the top three Monitor Dock PCB screws.
5 Connect board to the Interface PCBA. Connect to Monitor and
Dock boards.
6 Install the three screws removed in step 2 for option A. Install the
two screws removed in step 2 for options B or C.
Remove
Loosen
Connector Board
Remove
Interface PCBA
To Next Page
Loading...
