Spacelabs qube 91390 - Replace the Docking Station Push Button

www.spacelabshealthcare.com
4-34
91390
QUBE
M AINTENANCE
Figure 4-32 LED Wiring Assembly Connection J70
5 Remove the six (6) screws on the latch assembly. Refer to Figure
4-30 on page 4-33.
6 Carefully remove the pins, springs, and washers. Refer to Figure
4-30 on page 4-33.
7 Remove the two (2) screws from the push-button support
bracket.
8 Remove the push button.
9 Install the new latch assembly in reverse order.
10 Make sure that the docking station accepts the monitor correctly.
Replace the Docking Station Push Button
1 Do the steps to replace the docking station latch.
2 Remove the screws holding the push-button assembly. Refer to
Figure 4-30 on page 4-33.
3 Replace with a new push button.
4 Reassemble the unit in reverse order.
5 Make sure that the push button operates correctly by docking
and undocking a monitor.