SSD 605C - Page 12

Contents
Contents Page
Cont.12
Chapter 13 APPLICATION NOTES
Synchronous Motor Control ........................................................................ 13-1
Brake Motors .............................................................................................. 13-1
Using Line Chokes ...................................................................................... 13-2
Using Output Contactors............................................................................. 13-2
Using Motor Chokes ...................................................................................13-2
Using Multiple Motors on a Single Drive....................................................13-3
Dynamic Braking ........................................................................................13-3
Brake Resistor Selection .........................................................................................13-4
High Starting Torque .................................................................................. 13-5
Chapter 14 SERIAL COMMUNICATIONS
Communications Technology Option ..........................................................14-1
ConfigEd Lite ........................................................................................................14-1
Connection to the P3 Port ........................................................................... 14-1
Chapter 15 APPLICATION MACROS
The Default Application .............................................................................. 15-1
How to Load a Macro.................................................................................. 15-1
Macro Descriptions .....................................................................................15-1
Macro 0 ...............................................................................................................15-1
Macro 1: Basic Speed Control (default) ..................................................................15-3
Macro 2: Run Forward/Run Reverse .......................................................................15-5
Macro 3: Raise/Lower Trim....................................................................................15-7
Macro 4: Process PID ............................................................................................15-9
Macro 5: Preset Speeds .......................................................................................15-11
Macro 6: Closed-Loop Speed Feedback ...............................................................15-13
Macro 99: 584S Compatible Application .............................................................15-15
General Wiring Diagram for Macro 99 ................................................................15-18
Macro Control Blocks ..........................................................................................15-19
Macro User Blocks ..............................................................................................15-20