SSD 605C - The MMI DIAGNOSTICS Menu

5-8 The Operator Station
605C Frequency Inverter
The MMI DIAGNOSTICS Menu
SPEED DEMAND Tag No. 255 xxx.xh%
Actual speed demand.
(Refer to the REFERENCE function block )
REMOTE SETPOINT Tag No. 245
-300.00 to 300.00 %
Target remote reference used when ramping in remote reference mode.
(Refer to the REFERENCE function block )
COMMS SETPOINT Tag No. 269
-300.00 to 300.00 %
Target reference used when ramping in remote reference Comms mode.
(Refer to the REFERENCE function block )
LOCAL SETPOINT Tag No. 247
0.00 to 100.00 %
The Operator Station setpoint.
(Refer to the REFERENCE function block )
JOG SETPOINT Tag No. 246
0.00 to 100.00 %
Target reference used when ramping in local or remote reference Jog mode.
(Refer to the JOG function block)
DRIVE FREQUENCY Tag No. 591 xxx.xHz
The Inverter output frequency.
(Refer to the PATTERN GEN function block)
ENCODER SPEED Tag No. 568 xxxx.xHz
Speed feedback in Hz.
(Refer to the ENCODER function block)
ENCODER SPEED Tag No. 569 xxxxx n/min
Speed feedback in RPM
(Refer to the ENCODER function block)
ENCODER SPEED Tag No. 749 xxx.xx%
Speed feedback as a percentage of MAXIMUM SPEED.
(Refer to the ENCODER function block)
MOTOR CURRENT Tag No. 67 xxxx.xA
Level of rms line current being drawn from the Inverter.
(Refer to the CURRENT FEEDBACK function block)
LOAD Tag No. 207 xxx.xx%
Normalised version of the I TORQUE diagnostic: 100% = motor operating at rated load
(torque).
(Refer to the CURRENT FEEDBACK function block)
FIELD Tag No. 73 xxx.xh%
Normalised version of the MOTOR CURRENT diagnostic: 100% = motor operating at rated
magnetic flux (field).
(Refer to the CURRENT FEEDBACK function block)
CURRENT LIMITING Tag No. 370 FALSE / TRUE
Indicates if current limit is active (altering Inverter output frequency).
(Refer to the CURRENT LIMIT function block)
BRAKING Tag No. 81 FALSE / TRUE
Indicates the state of the brake switch.
(Refer to the DYNAMIC BRAKING function block)
DC LINK VOLTS Tag No. 75 xxxx.xV
The internal dc voltage being tested by the braking block.
(Refer to the CURRENT FEEDBACK function block)
ACTIVE TRIPS Tag No. 4 0000 to FFFF
Indictes which trips are currently active.
(Refer to the TRIPS STATUS function block)
ACTIVE TRIPS+ Tag No. 740 0000 to FFFF
Indictes which trips are currently active.
(Refer to the TRIPS STATUS function block)