EasyManuals Logo

ST ST32M103 Series User Manual

ST ST32M103 Series
519 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #127 background imageLoading...
Page #127 background image
UM0306 Real-Time Clock (RTC)
127/519
The functions of the RTC are controlled by this control register. It is not possible to write to
the RTC_CR register while the peripheral is completing a previous write operation (flagged
by RTOFF=0, see Section 8.3.4 on page 124).
Note: 1 Any flag remains pending until the appropriate RTC_CR request bit is reset by software,
indicating that the interrupt request has been granted.
2 At reset the interrupts are disabled, no interrupt requests are pending and it is possible to
write to the RTC registers.
3 The OWF, ALRF, SECF and RSF bits are not updated when the APB1 clock is not running.
4 The OWF, ALRF, SECF and RSF bits can only be set by hardware and only cleared by
5 If ALRF = 1 and ALRIE = 1, the RTC global interrupt is enabled. If EXTI Line 17 is also
enabled through the EXTI Controller, both the RTC global interrupt and the RTC Alarm
interrupt are enabled.
6 If ALRF = 1, the RTC Alarm interrupt is enabled if EXTI Line 17 is enabled through the EXTI
Controller in interrupt mode. When the EXTI Line 17 is enabled in event mode, a pulse is
generated on this line (no RTC Alarm interrupt generation).
www.BDTIC.com/ST

Table of Contents

Other manuals for ST ST32M103 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ST ST32M103 Series and is the answer not in the manual?

ST ST32M103 Series Specifications

General IconGeneral
BrandST
ModelST32M103 Series
CategoryMicrocontrollers
LanguageEnglish

Related product manuals