101TS 500i
: Place the wiring harness (1) of
the sensor into the guides
(arrows) – the wiring harness of
the injection valve must be
underneath
: Close the cover (1) and press
into the snap fittings (arrows)
until they snap into place
: Push the wiring harness (1) and
bushing (2) of the sensor
completely into the guides
(arrows)
1307RA181 TG
1
1307RA183 TG
1
2
1307RA193 TG
1
: Place the wiring harness (1) and
bushing (2) in the guides
(arrows) – start with the bushing
: Position the cable holder (1) so
that it engages over the bushing
(arrow) – do not pinch the leads
: Screw in the screw (2) and
tighten it
1307RA186 TG
1
2
1307RA187 TG
2
1
: Fit the cover (1) and guide the
cable lug of the ground wire (2)
between the tabs (arrows)
: Screw in the screw (3) and
tighten it
– Install the engine, b 6.5
– Reassemble remaining parts in
reverse order
11.5 Impulse hose
The impulse hose forms one unit
with the fuel hoses. Installation and
removal is described in the chapter
"Injection pump", b 11.7.2
1307RA188 TG
3
1
2
To Next Page
Loading...
