84 TS 500i
: Screw in the screw (1) and
tighten it
– Fit the muffler, b 6.1
9.2 Antivibration spring in
the support
The antivibration spring is located
between support and crankcase
and must be replaced if defective.
– Remove the support, b 9.6
: Unscrew screw (1) and remove
antivibration spring (2)
– Examine the antivibration spring
and replace it if necessary
1307RA034 TG
1
1307RA323 TG
1
2
Installation
: Push antivibration spring (1) as
far as possible into the mount
(arrow ) and hold it in position
– antivibration spring is secured
against twisting
: Screw in the screw (1) and
tighten it
– Install the support, b 9.6
1307RA324 TG
1
1307RA325 TG
1
9.3 Antivibration spring at
the bottom of the
crankcase
The antivibration spring is secured
underneath the machine and must
be replaced if defective.
: Remove screw (1)
– Remove front handlebar, b 9.5
: Pull the antivibration spring (1)
out of the handlebar
– Examine the antivibration spring
and replace it if necessary
1307RA326 TG
1
1
370RA262 TG
To Next Page
Loading...
