78 TS 500i
: Position the spring (1) so that the
loop of the spring encloses the
peg of the pawl and the curved
part of the spring (arrow) is
located in the groove in the
starter post.
: Then slide the straight part of the
spring over the starter post until it
engages in the groove
– Reassemble remaining parts in
reverse order
8.4 Rope rotor
Relieve tension of rewind spring
The system will not be under
tension if the starter rope or
rewind spring is broken.
– Remove starter, b 8.2
1
370RA222 TG
: Pull out the starter rope (1)
approx. 30 cm, then hold the
rope rotor (2) steady. The recess
(arrow) must point towards the
rope guide.
: Pull the starter rope (1) out
between the recess and rope
guide (arrow) with assembly
hook (2) 5910 893 8800.
: Hold the rope rotor (3) so that it
turns slowly until the tension of
the rewind spring has been
relieved.
: Pull out the twisted rope (1) with
the starter grip and straighten it
out.
1
2
370RA223 TG1307RA321 TG
2
1
3
1307RA322 TG
1
– Remove the spring and pull out
the pawl, b 8.3
The rewind spring must be relieved.
: Remove washer (1)
: Carefully pull off the rope rotor (2)
– Remove starter rope on the rope
rotor, b 8.5
– Examine the rope rotor and
replace it if necessary
– Coat the hole in the rope rotor
with STIHL special lubricant,
b 13
1307RA038 TG
2
1
To Next Page
Loading...
