41TS 500i
: Press the ball bearing fully home
with press arbor (1)
4224 893 7200
: Fit the circlip (1)
: Slide the clutch drum (1) into
place
: Slide on the ring (2)
– Reassemble remaining parts in
reverse order
370RA078 TG
1
370RA079 TG
1
1307RA059 TG
1
2
5.4 Studs for securing the
"cast arm with guard"
– Remove the "cast arm with
guard", b 4.2
: Fit the stud puller (1)
5910 893 0501 over the studs
(arrows) as far as possible and
unscrew
: Coat the thread (arrows) of the
studs with Loctite before fitting
them, b 13
– Use the stud driver
5910 890 3000 to screw in and
tighten the studs
– Reassemble remaining parts in
reverse order
1307RA060 TG
1
1307RA061 TG
To Next Page
Loading...
