26 TS 500i
: Pull the water hose (1) out of the
guides (arrows).
: Apply a screwdriver to the hose
clip (arrow) and turn slightly to
open the clip.
: Pull off the hose (1).
Installation
– Push hose clip onto water hose
370RA013 TG
1
1307RA001 TG
1
1307RA002 TG
12
: Push water hose (1) as far as
possible onto the support of the
solenoid valve, then align the
hose clip (2)
: Press the tabs (arrows) on the
hose clip (2) together until they
engage
– Push hose clip onto water hose
: Push water hose (1) as far as
possible onto the support of the
nozzle, then align the hose
clip (2)
: Press the tabs (arrows) on the
hose clip (2) together until they
engage
– Starting from the solenoid valve,
route the water hose (1) without
any tight bends or kinks.
1307RA015 TG
21
370RA044 TG
1
: Press the water hose (1) into the
guides (arrows)
4.1.3 Solenoid valve
– Troubleshooting, b 3.3
– Disconnect the water hose from
the solenoid valve, b 4.1.2
: Remove screw (1) on the bottom
of the machine and remove the
cover (2)
: Pull insulating tubes with plug
connections (1, 2) out of the
guides
1307RA003 TG
1
2
1
2
1307RA004 TG
To Next Page
Loading...
