86 TS 500i
Bearing plug (1) must be twisted
into the antivibration spring as far as
it will go.
: Push the bearing plug (1) into the
mount (arrow) and hold it in
position
: Screw in the screw (1) and
tighten it
– Reassemble remaining parts in
reverse order
1307RA331 TG
1
1307RA328 TG
1
9.5 Handlebar
– Remove the support, b 9.6
: Unscrew screw (1) and remove
clamp (2)
: Unscrew the screw (1)
: Unscrew the screw (1) on the
bottom and remove clamp (2)
1307RA021 TG
2
1
1307RA326 TG
1
1307RA333 TG
1
1
1
2
: Remove handlebar (1) and pull
out antivibration spring (2)
: Remove the clamp (3)
– Examine the individual parts,
replace if necessary
Installation
: Push the antivibration spring (1)
into the handlebar so that the
tab (2) engages in the notch
(arrow)
: Fit the clamp (1) onto the
handlebar so that the lug (2)
engages in the hole (arrow).
1307RA334 TG
2
13
1
370RA263 TG
2
1
2
370RA272 TG
To Next Page
Loading...
