Stihl TS 500i - Trigger Interlock

92 TS 500i
: Lay the leaf spring (1) on the
cams of the switch shaft (2) and
press it into the mount (arrow)
– Hook the torsion spring into the
trigger interlock
: Set the switch shaft (1) to
position "STOP" or "0".
– Checking correct functioning
– in position "STOP" or "0" the
switch shaft must actuate the
switch
The switch shaft can only be set to
position "F" if the trigger interlock
and throttle trigger are pressed.
1307RA244 TG
21
1307RA245 TG
1
: Guide the handle molding (1) into
position under the pegs (arrows)
– Insert and tighten the screw
10.2 Throttle trigger / trigger
interlock
– Remove the handle molding,
b 10.1
: Unhook the torsion spring (1)
from the trigger interlock (arrow)
and remove the trigger
interlock (2)
: Unhook the throttle cable (1)
from the throttle trigger (2)
370RA303 TG
1
1307RA246 TG
2
1
1307RA086 TG
1
2
: Drive the pin (arrow) out with a
drift
: Take out the throttle trigger (1)
and torsion spring (2)
– Examine the individual parts,
replace if necessary
: Hook the torsion spring (1) into
the throttle trigger (2)
– Note the installed position
(arrow)
1307RA247 TG1307RA248 TG
2
1
370RA307 TG
1
2