85TS 500i
Installation
: Push the antivibration spring (1)
into the handlebar so that the
tab (2) engages in the notch
(arrow)
– Mount the handlebar on the
machine, b 9.5
Bearing plug (1) must be twisted
into the antivibration spring as far as
it will go.
: Push the bearing plug (1) into the
mount (arrow) and hold it in
position
1
370RA263 TG
2
1307RA327 TG
1
: Screw in the screw (1) and
tighten it
– Install handlebar, b 9.5
9.4 Antivibration spring on
throttle shutter housing
The antivibration spring is located
near the throttle shutter housing
between tank housing and
crankcase, and must be replaced if
defective.
– Remove shroud, b 6.4
– Remove control unit, b 7.3
: Unscrew the screw (1)
1307RA326 TG
1
1307RA328 TG
1
: Unscrew the screw (1)
: Remove the antivibration
spring (2) and examine it,
replace if necessary
Installation
: Push the antivibration spring (1)
into the mount (arrow)
: Screw in the screw (2) and
tighten it
1307RA329 TG
12
1307RA330 TG
21
To Next Page
Loading...
