32 TS 500i
– Fit the connector (1) with water
hose and align it at a right angle
to the adjusting lever (2).
: Insert square nut on the inside,
screw in banjo screw (3) and
tighten
: Starting from the solenoid valve,
route the water hose (1) so that
there are no tight bends or kinks
: Press the water hose (1) into the
guides (arrows)
1307RA364 TG
2
3
1
370RA044 TG
1
4.2.1 Ball bearing
– Remove the "cast arm with
guard", b 4.2
– Remove the guard on the cast
arm, b 4.2
: Remove the circlips (1) on both
sides
: Drive the ball bearing out of the
cast arm with press arbor (1)
4224 893 7200
Always use new grooved ball
bearings.
1307RA363 TG
1
370RA027 TG
1
Installation
: Fit a circlip (1) as stop in the cast
arm
– Align the press arbor (1)
4224 893 7200 – the ball bearing
and ring are pushed onto the long
peg (arrow)
: Slide the first grooved ball
bearing (2), ring (3) and second
grooved ball bearing (4) onto the
peg (arrow)
1307RA362 TG
1
1307RA036 TG
11
2
3
4
To Next Page
Loading...
