107TS 500i
11.8.3 Fuel tank filler cap
– See Instruction Manual.
11.9 Tank housing
– Empty the fuel tank
– Dispose of the fuel, b 1
– Remove the shroud, b 6.4
– Remove the control unit, b 7.3
– Remove the solenoid valve
(water connection), b 4.1.3
– Remove the handlebar, b 9.5
– Remove the pickup body,
b 11.8.1
: Unhook the throttle cable (1)
from the mount (arrow)
: Raise the retaining tab (2) slightly
and pull out the air baffle (3)
1307RA161 TG
1
2
3
: Pull the injection pump (1) from
the guides and pry out the
connecting element (2) using
the tab (arrow)
: Pull out the hose holder (1) and
connecting element (2) and set
aside with the injection pump (3)
: Loosen the screw and push the
hose clip (1) in the direction of the
throttle shutter housing
: Push down the manifold (2) from
the tank housing support
1307RA222 TG
1
2
1307RA223 TG
1
2
3
1307RA224 TG
1
2
: Unscrew the screw (1) and
pull the bearing plug of the
antivibration spring (2) out of
the mount
: Pull the tank housing (1)
downwards at the opening
(arrow) out of the hose and
remove
– Examine the tank housing,
replace if necessary
Those parts of the old tank housing
which are not supplied with the new
tank housing must be reused – see
spare parts list.
– Check the air baffle, wiring
harness solenoid valve and
support foot, replace or
reconfigure if necessary,
b 9.6.2, b 9.6.3
If the tank housing is installed again,
check the bushing for the
connecting element, replace if
necessary.
– Remove the flywheel, b 7.5
– Remove the generator, b 7.5.1
1307RA225 TG
1
2
1307RA226 TG
1
To Next Page
Loading...
