Still MX-X Original Instructions

2 Safety
Working safely
Working safely
• The industrial truck must be operated
exclusively from the driver's compartment
• If industrial trucks are equipped for pedes-
trian mode or with external operating pan-
els, the industrial trucks may be operated
using these features; for further safety infor-
mation for this purpose, refer to the relevant
additional descriptions
• When driving without a load,
lower the fork
to floor height
• When driving with a load, the load must be
lifted a few centimetres off the ground (clear
of the ground, max. 500 mm)
• The driver must keep all body parts within
the contours of the driver's compartment;
the driver must refrain from sticking his head
out to gain a better view and from reaching
into the area of the moving lift mast because
doing this is highly dangerous
• Aside from the driver, the
re must be no
other person present on t
he industrial truck
unless the industrial tr
uck has additional
equipment to enable oper
ation with two
persons
• Basically, it is the driver's duty to adapt his
driving speed to the local conditions and
the respective situation. When cornering
in particular, attention must be paid to the
overall height and the centre of gravity,
which will be high as a result.
• When cornering and driving past parts of
buildings that restrict visibility, use the horn
to warn others that the industrial truck is
approaching.
• When driving through doorways and un
der
ceiling joists, take the height of th
e industrial
truck into consideration.
• Multiple operations or other types of oper-
ations not described here, especially the
blocking or disabling of operating devices,
can cause damage to the industrial truck
but also uncontrolled movements and are
therefore prohibited
• The driver must secure the industrial truck
against unauthorised use by removing and
taking the switch key or by clearing the
access information on the electronic access
control system when leaving the industrial
truck.
Safe working environment
• People must not encroach into the working
area (danger area) of the industrial truck;
If a person does enter the danger area, all
movements of the industrial truck must be
stopped immediately and the person must
be directed away from the area
• If there are marked roadway
s, the industrial
truck must be moved only wit
hin these
markings for safety reaso
ns
• It is never permitted for anyone to stand be-
neath a raised load or driver's compartment.
• The condition of the floor surface influences
the braking distance of the industrial truck.
The driver must take account of this in his
driving and braking style.
• If the area of applicati
on and work situ-
ation so require, the op
erating company
must evaluate the poten
tial hazards and
provide appropriate pe
rsonal protective
equipment such as safet
y shoes, a safety
helmet, safety gloves
or protection goggles:
responsibility for th
e selection and provision
lies with the operatin
g company; responsi-
bility for use of the e
quipment lies with the
operator
Safe machine
• Essentially, all safety information located
on the industrial truck must be observed
• Missing or illegible safety information must
be replaced
• The openings in th
e area of the battery
where gas may be re
leased must not be
covered or sealed
. To prevent the formation
of potentially expl
osive gas mixtures, an
unrestricted air su
pply is required.
• Under no circumstances should openings
be made in the battery's gassing area,
which could allow the gas created during
charging to enter the area of the driver's
compartment.
10 5
231 804 2502 EN - 11/2017

Still MX-X Specifications

General

Brand	Still
Model	MX-X
Category	Forklifts
Language	English