4 Operation
Parking, decommissioning
and the system must be stored in optimum
conditions.
Once the last numbered seal has been used,
the entire system must be replaced.
Two-person cab
Industrial trucks which fe
ature a cab that
permits two operators must
also be equipped
with two abseil systems.
In such trucks, it must be ensured that only the
suspension points approved by the manufac-
turer are used.
Different operators
If an industrial truck is used by multiple
persons, e.g. in multi-shift use, it may be
indicated that several preset abseil systems
must be kept on hand. This is particularly
sensible if the different operators are of widely
varying heights and/or weights and the safety
harness would therefore have to be adjusted
to a significant degree.
In such trucks, it must
be ensured that only the
suspension points app
roved by the manufac-
turer are used.
Parking, decommissi
oning
Parking and leaving t
he truck
NOTE
It is the operator's duty to remove the ignition
key when he leaves the truck, thus securing
the truck against unauthorised use. If the
truck is equipped with an electronic access
control, it must be reset and/or the device for
controlling access must be removed. Where
possible, the truck should be parked at the
start of a racking aisle or in a loading bay. If
there are parking spaces, the truck must be
parked there. The fork is to be lowered to the
floor as far as possible, and if there is one, the
tilt attachment must tilt towards the floor to
reduce the risk of stumbling.
82 5
231 804 2502 EN - 11/2017
To Next Page
Loading...
Need help?
General
