Overview 3
Intended use
Intended use
The order picker truck is designed for narrow
aisle operation. It permits pallets to be entered
into and removed from storage, as well as
order picking from the rack compartments.
Observe the instructions in the paragraph
"safety".
The maximum load that can be l
ifted is speci-
fied on the loadbearing infor
mation plate (load
diagram) and must not be exce
eded.
Use for other purposes is prohibited.
If this truck is to be used for work which is not
described in these instructions or does not
appear in the guidelines for the specified and
proper use of industrial trucks, and if it has to
be converted and retrofitted for this purpose,
it is necessary to be aware that modifications
to the original construction can impair the
driving behaviour and stability of the truck
and are therefore not permitted without our
agreement.
Add-on parts and modific
ations (e.g. the weld-
ing-on of parts or the cr
eation of openings)
could weaken the suppor
ting structure and are
therefore only permitt
ed after acceptance by
our design department.
Functional changes
through modifications t
o the electrical system
or the software also req
uire our acceptance
and release.
Before any such work is done you should
therefore make contact with the branch office
or the specialist representative in your area.
Description of truck
Instructions on operation of the individual
functions are provided in the respective
chapters.
General information
The operator can put himself and the load
suspension device (swivel fork) into the
most suitable working height by raising the
operator's cabin. The auxiliary lift can be used
to serve the highest rack level and to set a
523
1 804 2502 EN - 11/2017 27
To Next Page
Loading...
Need help?
General
