Still MX-X - Battery Compartment Cover; Installing the Battery

4 Operation
General commissioning
Battery compartment cover
The battery compartment cover covers the
entire battery compartment. The cover rests
loosely over the compartment.
All that is needed to operate the battery male
connector is to open the service flap.
NOTE
As an option, the industrial truck can be
equipped with lateral battery compartment
doors.
Installing the battery
The battery must fill the installation space
with just a few millimetres of play. This will
ensure that the battery does not slip or tip
over during travel and that the function of the
battery lock is guaranteed. If a lighter battery
is used temporarily, you must compensate
for the weight difference using a fixed ballast,
and the size difference must be equalised
using shims. In this case, the specifications
on the nameplate of the industrial truck must
be changed or updated. These narrow aisle
trucks are equipped with an integrated battery
discharge indicator that is set for normal wet
lead batteries (PzS) as standard. If a different
battery type or different battery capacity is
used, the authorised service partner must
adapt the battery discharge indicator.
NOTE
The voltage and weight of the battery must
satisfy the requirements set out on the truck's
nameplate. Therefore, you need to compare
the nameplates on the truck and battery.
Battery type and battery charger
Wet lead batteries, gel batteries or lithium-ion
batteries can be used as traction batteries.
Because the various types have different
50 5
231 804 2502 EN - 11/2017