Special equipment 7
Intermediate lift cut out
Intermediate lift cut out
Lifting operation is stopped at a previously
determined lift height. The ring around the
enable button (1) lights up. This cut out can
be overridden once the enable button has
been pressed. This equipment is therefore
necessary if the truck is used in two (or three)
different high buildings, for example.
NOTE
Alternatively, this function can also be modi-
fied so that it is necessary to press and hold
the enable button in order to continue lifting.
Mounting system for auxiliary
components
The driver's cab can be equipped with a sys-
tem consisting of rods and support mountings
in order to mount additional components.
Additional components may include:
• Writing surface with paper clip (1)
• Storage area for barcode scanner gun (2)
• Support mounting for data terminal
• Support mounting for printer
NOTE
The support
mountings and clamping devices
must always
be in perfect condition so that the
auxiliary c
omponents do not move from their
installed pos
itions during travel.
Aisle entry as
sistant
General
Theaisleentryassistantcanbeusedtomake
it easier to drive into an aisle when using me-
chanical guidance. To do this, the truck re-
ceives electrical and mechanical equipment,
like a truck with inductive guidance.
523
1 804 2502 EN - 11/2017 105
To Next Page
Loading...
