7 Special equipment
Inductive guidance (IZF)
Automatic driving within the aisle
To operate the industrial truck in automatic
driving mode, the left-hand sensor surface
for two-hand operation (7) and the right-hand
operating lever (6) must be actuated. If the
cab lift needs to be lifted or lowered at the
same time as this, both operating levers must
be actuated accordingly. If the steering knob
is accidentally turned to its straight-ahead
position (middle stop) during automatic drive
mode, the industrial truck is automatically
braked to a standstill.
Switching from automatic m
ode to manual
mode within the aisle
If the industrial truck is accidentally switched
to manual steering within the aisle, the truck
is immediately braked to a standstill. It is then
only possible to continue at creep speed.
Driving speed adaptation
The automatic speed adap
tation feature
adjusts the maximum pos
sible driving speed
accordingtothecurren
t situation. If an unsafe
situation arises, for e
xample an error occurs,
the driving speed is lim
ited or the driving
function is switched of
f completely.
Leaving the inductio
ntrack
– Drive the entire length of the industrial truck
out of the aisle.
– Turn off automatic steering by pushing the
"man/auto" (1) button again.
– The industrial truck i
s braked automatically.
– An acoustic signal sounds.
– Drive the industrial truck away from the
wire groove using manual steering. The
maximum permissible speed outside of the
aisle is possible.
Changing the aisle
If the industrial truck is driven from one aisle
to another, it is essential that the notes in the
chapter "Changing the aisle" are observed.
104
5231 804 2502 EN - 11/2017
To Next Page
Loading...
